MSI 6741 DRIVER DOWNLOAD

Locate the CPU and its retention mechanism on the motherboard. Before inserting the power supply connector, always make sure that all components are installed properly to ensure that no damage will be caused. To connect to the ATX power supply, make sure the plug of the power supply is inserted in the proper orientation and the pins are aligned. It supports a three-pin head connector. You can install either single- or double-sided modules in any order to meet your own needs. It introduces a 66MHz, bit channel for the graphics controller to directly access main memory. When you are installing the CPU, make sure the CPU has a heat sink and a cooling fan attached on the top to prevent overheating.

Uploader: Zujar
Date Added: 4 February 2004
File Size: 61.13 Mb
Operating Systems: Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X
Downloads: 60680
Price: Free* [*Free Regsitration Required]

AGP is an interface specification designed for the throughput demands of 3D graphics.

Meanwhile, read the documentation for the expansion card to make any necessary hardware or software settings for the expansion card, such 641 jumpers, switches or BIOS configuration. Connect the fan power cable from the mounted fan to the 3-pin fan power connector on the board.

The CPU can only fit in the correct orientation. You can attach a serial mouse or other serial devices directly to the connector. Jsi can clear CMOS by shorting pin while the system is off. Getting Started Chapter 1.

Then return to pin position. J9 Optional You can connect a joystick or game pad to this connector. Line In is used for external CD player, Tape player, or other audio devices. Overheating Overheating will seriously damage the CPU and system, always make sure the cooling fan can work properly to protect the CPU from overheating.

  1284.4 PRINTER DRIVER DOWNLOAD

MSI K8MM-ILSR – motherboard – micro ATX – Socket 754 – K8M800 Series

Please turn off the power and unplug the power cord before installing the CPU. If you install two hard disks on cable, you must configure the second drive to Slave mode by setting its jumper. Memory modules can be installed in any combination as follows: Follow the instructions below to clear the data: The connector location and pin assignments are as follows: The jsi arrow should point towards the lever pivot.

67741 Disk Drive Connector: When adding or removing expansion cards, make sure that you unplug the power supply first. When you are installing the CPU, make sure the CPU has a heat sink and a cooling fan attached on the top to prevent overheating.

Each lever can be pressed down in only ONE direction. Pull the lever sideways away from the socket. The module will only fit in the right orientation. While doing the installation, be careful in holding the components and follow the installation procedures.

Press the two levers down to fasten Press down the fan until mei four clips get wedged in the holes 6714 the retention mechanism. Then push it in until the golden finger on the memory module is deeply inserted in the socket.

  MOTORAZR2 V9X DRIVER DOWNLOAD

MS MOTHERBOARD | Emachines MS K8T Motherboard

To connect to the ATX power supply, make sure the plug of the power supply is inserted in the proper orientation and the pins are aligned. As the CPU is likely to move while the lever is being closed, always close the lever with your fingers pressing tightly on top of the CPU to make sure the CPU is properly and completely embedded into the socket.

Position the heatsink onto the retention mechanism. Make sure to raise the lever up to a 90degree angle. Always consult the vendors for proper CPU cooling fan. Look for the gold arrow. You must configure second hard drive to Slave mode by setting the jumper accordingly. Mic is a connector for microphones.

Hardware Setup Hardware Setup This chapter tells you how to install the CPU, memory modules, and expansion cards, as well as how to setup the jumpers on the mainboard. Before inserting 67741 power supply connector, always make sure that all components are installed properly to ensure that no damage will be caused.

You can barely see the golden finger if the module is properly inserted in the socket.